Chip tuning BMW 330i E90 272hp

The setup for BMW 330i E90 applies to a petrol vehicle with an original output of 272 hp. A different generation or factory power version should be matched to its own catalogue entry.

Listed tuning targets

• Power: factory figure 272 hp; listed tuned figure 291 hp (+19 hp).
• Torque: factory figure 320 Nm; listed tuned figure 340 Nm (+20 Nm).
• 0–100 km/h acceleration: factory figure 6.2 s; listed tuned figure 5.9 s (−0.3 s).
• Listed maximum speed: factory figure 250 km/h; listed tuned figure 265 km/h (+15 km/h).

For the factory 272 hp / 320 Nm version, the listed increases correspond to approximately 7.0% more power and 6.2% more torque. These percentages are calculated from this entry and help compare different catalogue configurations.

The figures describe the listed tuning configuration. Actual output and acceleration depend on vehicle condition and test conditions; the numbers do not replace an individual measurement.

Configuration options

The form for this petrol version lets you select Stage 1 / Stage 2 and discuss the following items: Popcorn, selected DTC deactivation, catalyst deactivation, EVAP / DMTL deactivation, VMax speed limiter adjustment, rev limiter adjustment.

The final selection depends on the actual equipment and ECU version. A selection in the form is a request for confirmation, not a guarantee that every function is supported or required.

For the E90 generation, the software read/write method is agreed after ECU identification. The model badge alone does not identify the required interface or connection procedure.

For a tuning selection for BMW 330i E90, provide the VIN, current software details and requested tasks. This entry is used as a reference after checking that it matches the vehicle.